LS7366R-S
LS7366R-S

 

LS7366R-S

Utsource Holding Company Limited flag
Category: Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY LS7366R-S https://www.utsource.net/itm/p/12541611.html

Parameter Symbol Min Typ Max Unit Description
Supply Voltage VDD 2.7 - 5.5 V Operating voltage range
Supply Current (Active) IDD - 1.0 1.5 mA Typical supply current at 3.3V, 25°C
Supply Current (Standby) IDD - 0.1 0.2 μA Typical supply current in standby mode, 3.3V, 25°C
Operating Temperature Toper -40 - 85 °C Operating temperature range
Storage Temperature Tstg -65 - 150 °C Storage temperature range
Input Frequency fIN - - 20 MHz Maximum input frequency
Counter Resolution N 1 - 32 bits Counter resolution
Output Load Current IOL - 10 24 mA Maximum output sink current per pin
Output High Voltage VOH 2.4 - VDD V Minimum output high voltage level
Output Low Voltage VOL 0 - 0.4 V Maximum output low voltage level
Reset Time tRST 0 1 2 μs Time required for counter to reset
Read/Write Cycle Time tRW 0 100 200 ns Time required for read/write cycle

Instructions

  1. Power Supply:

    • Ensure the supply voltage (VDD) is within the range of 2.7V to 5.5V.
    • Connect the power supply to the VDD and GND pins.

  2. Reset:

    • To reset the counter, apply a low pulse to the RST pin for at least 1 μs.

  3. Input Signal:

    • Connect the input signal to the CLK pin. The maximum input frequency is 20 MHz.

  4. Counter Configuration:

    • Set the counter resolution by configuring the appropriate registers. The counter can be set to 1 to 32 bits.

  5. Reading the Counter:

    • Use the read cycle time (tRW) to ensure proper timing when reading the counter value. The typical read/write cycle time is 100 ns to 200 ns.

  6. Output:

    • The output load current (IOL) should not exceed 24 mA per pin.
    • Ensure the output high voltage (VOH) and output low voltage (VOL) levels are within the specified ranges.

  7. Temperature Considerations:

    • Operate the device within the temperature range of -40°C to 85°C.
    • Store the device within the temperature range of -65°C to 150°C.

  8. Standby Mode:

    • To enter standby mode, set the appropriate register bit. The typical supply current in standby mode is 0.1 μA to 0.2 μA.

  9. Programming:

    • Refer to the device datasheet for detailed programming instructions and register configurations.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag