In a high-rise fire, the Staircase and Lobby Pressurization System is the only thing standing between occupants and toxic smoke inhalation. Testing is not just a "check-box" exercise; it is a mechanical stress test of the building's "Safety Envelope." In Kuala Lumpur’s 2026 regulatory environment, BOMBA (Fire Department) and UBBL standards require these systems to hit precise Pascal (Pa) and velocity targets to ensure a safe evacuation.
As part of a Ventilation Systems Audit, EKG performs rigorous Testing & Commissioning (T&C) to ensure your fans don't just "spin," but actually protect.
To be compliant, your system must achieve a precise atmospheric balance:
The "Magic" Number (50 Pa): The staircase must be held at a positive pressure of 50 Pascals ($\pm 10\%$). This creates a "Pressure Shield" that physically blocks smoke from entering the stairwell.
The Force Limit (110N): If the pressure is too high (e.g., 100 Pa), a child or elderly person may not have the physical strength to pull the fire door open. We test to ensure the opening force never exceeds 110 Newtons.
Air Curtain Velocity (1.0 m/s): When a door is opened, the fan must instantly ramp up to provide an air "blast" of at least 1.0 meter per second across the doorway, preventing smoke "backflow."
We simulate an actual fire emergency to find "Hidden Faults" in your mechanical defenses:
Stairwell Pressure Mapping: We use digital manometers to map the pressure gradient from the ground floor to the roof. We identify "Leakage Zones" where air is escaping through poorly sealed service ducts or lift shafts.
VFD "Fire Mode" Validation: we audit the Variable Frequency Drive (VFD). In a fire, the VFD must ignore "Soft Faults" (like motor overheating) and run until the motor physically fails to keep the stairs clear.
Response Time Audit: We measure the seconds between the fire alarm trigger and the fan reaching its target RPM. Compliance usually requires a "Steady State" in under 60 seconds.
The "Door-Open/Door-Closed" Cycle: We test the system's ability to "recover" pressure quickly when multiple doors are being used for evacuation.
A "tested" system is also an efficient one. Many fans in KL are "over-speeding" to compensate for leaks, which wastes massive amounts of energy during mandatory monthly tests.
Friction Identification: A fan with worn bearings or misaligned belts requires more speed (Hz) to hit its 50 Pa target.
The Logic: Because of the Cube Law, if we restore mechanical efficiency (alignment/lubrication), we can often lower the fan speed on the VFD.
Reducing fan speed by just 10% can reduce the power consumption by nearly 30% during your testing cycles.
| Test Parameter | Target Performance | Safety Risk of Failure |
| Static Pressure | 50 Pa (+/- 10%) | Smoke Ingress (Low) / Stuck Doors (High) |
| Door Opening Force | Max 110 Newtons | Entrapment during Evacuation |
| Air Velocity | Min 1.0 m/s (Door Open) | Smoke Backflow into Stairwell |
| Genset Changeover | < 10 Seconds | Total System Failure during Blackout |
| Motor Vibration | < 2.8 mm/s | Bearing Seizure during Emergency |
BOMBA Form G Documentation: We provide the comprehensive technical reports and "Witness Logs" required for your annual Fire Certificate (FC) renewal.
Mechanical Restoration Path: We don't just "fail" your system. We are experts in Mechanical Fan Overhauls, offering on-site dynamic balancing, bearing replacements, and laser alignment to get you back to compliance.
VFD ROI Projection: We optimize your fan setpoints to ensure "Precision Pressurization," saving energy while maintaining 100% safety.
Precision Metrology: We use laboratory-grade pressure gauges and thermal cameras to identify "Hot Spots" in your control panels before they fail.
Malaysia
