In the 2026 Malaysian regulatory environment, the Fire-Rated Ducting & Smoke Damper Setup is the most critical safety interface in a building's HVAC system. Under the Uniform Building By-Laws (UBBL) 2024 and BOMBA (JBPM) 2026 enforcement, ducting is no longer just an air carrier; it is a life-safety conduit that must prevent the spread of toxic smoke and fire between compartments.
At EKG (Malaysia) SDN BHD, we engineer fire-rated setups to be Statutory-Compliant, Robust, and Integrated, ensuring your facility passes the mandatory annual Fire Certificate (FC) audit.
Every duct penetration through a fire-rated floor or wall is a potential weakness. Malaysian law mandates specific protection levels based on the building type.
Fire Rating (FRR): Ducting must match the Fire Resistance Rating of the compartment it penetrates (typically 1 to 4 hours). This is achieved through specialized fire-wrap insulation or pre-fabricated fire-rated steel.
Smoke Control (Smoke Spill): Under MS 1780:2024, ducts used for smoke extraction must maintain their structural integrity at temperatures exceeding 250°C for a minimum of 2 hours.
Leakage Integrity: During an emergency, fire-rated ducting must exhibit zero "break-out" of smoke, protecting escape routes like stairwells and lobbies.
A compliant EKG installation utilizes a "Fail-Safe" hierarchy of components.
| Component | 2026 Engineering Standard | Statutory Purpose |
| Motorized Smoke Damper | UL 555S / MS 2586 | Seals the duct against smoke when triggered by a detector. |
| Fusible Link Fire Damper | Mechanical Gravity/Spring | Closes automatically when temperatures reach 74°C. |
| Intumescent Fire Stopping | Hilti/3M Certified Systems | Seals the gap between the duct and the wall penetration. |
| Fire-Rated Hangers | Heavy-Duty Threaded Rods | Ensures ducting does not collapse during intense heat. |
The setup is only effective if it is correctly integrated with the building's Fire Alarm Monitoring System (FAMS) and the VFD-driven AHU.
The "Close-to-Stop" Sequence: When the FAMS detects smoke, it sends a signal to the Motorized Smoke Damper to close. Simultaneously, the AHU VFD must initiate a "Safe Stop" to prevent the fan from over-pressurizing and potentially bursting the ductwork against a closed damper.
Fire Mode Override: In some "Smoke Spill" designs, the VFD is programmed to ramp up to 100% speed while dampers to non-fire zones close, creating a "Pressure Sandwich" that keeps smoke contained in the fire zone.
Position Feedback: In 2026, all dampers must provide "End-Switch" feedback to the central fire panel. This allows BOMBA inspectors to verify that every damper has physically closed during a test.
For ducts passing through "Protected Corridors," external fire wrapping is mandatory.
Materials: EKG utilizes high-density mineral wool or calcium silicate boards. These materials are non-combustible (Class 0) and provide the necessary thermal barrier to prevent the duct from igniting nearby materials through radiant heat.
Installation Integrity: The wrap must be continuous. Any "gap" for a hanger or a sensor is a statutory failure. We utilize specialized fire-rated sealants at every support point to maintain the FRR.
Technical Integrity: Our fire-safety setups are led by mechanical specialists who understand the complex logic between smoke detectors, dampers, and VFDs.
BOMBA Audit Readiness: We provide the "Dampers Test Log" and "Certificate of Completion" required for your annual Fire Certificate (FC) witness test.
BIM-Coordinated Safety: We use 3D modeling to ensure that dampers are installed in accessible locations. If an inspector cannot reach a damper to test it, the building cannot be certified.
Is your smoke damper setup correctly linked to your fire alarm and AHU VFD?
Contact EKG (Malaysia) SDN BHD today for a specialized Fire-Rated Ducting & Smoke Control Audit.
Lebih maklumat tentang EKG M & E SDN BHD
Malaysia
