Nippon Paint Metallic Paint is a premium thermoplastic-acrylic solvent-based paint specifically designed to provide a luxurious, smooth metallic shimmer finish. It is a versatile coating that can be applied to a variety of substrates, including masonry walls, wood, and metal surfaces, both internally and externally. Formulated for easy application by brush or roller, it ensures a uniform distribution of metallic pigments across the substrate, creating a consistent and elegant effect. This paint is ideal for decorative projects, architectural highlights, and protective purposes where a high-end metallic aesthetic is desired.
Paint Type: Solvent-based (Thermoplastic-acrylic)
Finishing: Gloss Metallic Effect
Binder: Thermoplastic Acrylic Resin
Thinning: Nippon Acrylic 3000 Thinner (Ready to use; dilute only if necessary)
Touch Dry: 15 minutes (at 30°C)
Hard Dry: 45 minutes (at 30°C)
Recoating Interval: Minimum 2 hours
Theoretical Coverage: 9 – 11 m² per litre per coat (at 30-35 microns DFT)
No. of Coats: Minimum 2 coats
Shelf Life: Up to 36 months in a tightly sealed container
Mixing: Stir the paint thoroughly before use to ensure the metallic pigments are well-distributed.
Application Method: Apply using a high-quality Brush, Roller, or Conventional Air Spray.
Spray: Dilute with Acrylic 3000 Thinner as required to achieve the desired atomization.
Cleaning: All equipment should be cleaned with Nippon Acrylic 3000 Thinner immediately after use.
Note: Avoid application during wet weather or high humidity (above 85%) as it may affect the metallic luster.
For Masonry (Brick, Plaster, Fiber Board):
Sealer (1 Coat): Hydro Primer / 5200 Wall Sealer / 5400 Wall Sealer.
Topcoat (2 Coats): Metallic Paint.
For Metal (Ferrous):
Primer (1 Coat): Aquatec Red Oxide Primer / 8048 Zinc Phosphate Primer.
Topcoat (2 Coats): Metallic Paint.
For Wood:
Primer (1 Coat): Hydro Primer or Aqua Primer Sealer Undercoat.
Topcoat (2 Coats): Metallic Paint.
General Cleaning: Surfaces must be dry, clean, and free from dirt, grease, oil, and loose matter.
Removal: Remove all loose, defective paint or powdery residues, loose chalk, and dust by scraping or wire brushing.
Repair: Fill cracks and uneven surfaces with a suitable filler (e.g., Multi-purpose Joint Compound). Smoothen repaired areas with sandpaper before priming.
Fungus/Algae: Treat affected areas with Nippon Anti-Fungus Solution and leave for at least 2 hours before washing off.
Moisture Content: For masonry, ensure moisture content is below 16% (measured by protimeter) and alkalinity is below pH 9.
Metal Preparation: For rusted steel, mechanical cleaning to St 3 (wire brushing/grinding) is required before priming.
Malaysia
