In the event of a fire within a car park or industrial facility, the High Temperature Axial Flow Fan—often referred to as a Smoke Spill Fan—is the most critical piece of life-safety equipment. These fans are specifically engineered to extract superheated toxic gases, maintaining a clear air layer for evacuation and preventing the building's structural collapse. EKG M & E Sdn Bhd specializes in the selection, installation, and certified testing of these heavy-duty units across KL and PJ.
Certified Thermal Endurance (250 degree celcius to 400 degree celcius)
Our fans are tested and certified to international standards (such as EN 12101-3). They are guaranteed to operate at maximum RPM for at least 2 hours at 250 degree celcius (standard) or higher, ensuring they do not seize or melt during a fully developed vehicle fire.
Adjustable Pitch Aerofoil Blades
The impellers are cast from high-grade aluminum alloy or stainless steel. The adjustable pitch allows our M&E engineers to "fine-tune" the airflow and pressure on-site, ensuring the fan meets the exact Cubic Feet per Minute (CFM) required for your basement's volume.
Class H Insulated Fire-Rated Motors
We utilize specialized motors with Class H insulation and high-temperature grease. These motors are designed to withstand extreme ambient heat without the internal windings short-circuiting, providing the "dual-purpose" reliability needed for both daily $CO$ exhaust and emergency smoke extraction.
Aerodynamic Long-Casing Design
The axial flow design allows for high volumes of air to be moved in a straight line, which is ideal for vertical exhaust shafts. The long-casing protects the motor and internal components from external debris and mechanical damage.
Emergency Fire Mode Bypass Logic
When integrated into our control panels, these fans feature a "Fire Priority" circuit. In the event of a fire, the system bypasses all thermal overloads and safety trips—the fan is programmed to "run to destruction" to save lives, ignoring any faults that would normally stop a standard HVAC fan.
Vibration Isolation & Structural Mounting
Given the massive torque and thrust generated by axial fans, we use heavy-duty spring isolators and reinforced steel brackets. This prevents mechanical vibrations from damaging the building's concrete structure or creating noise nuisance for floors above.
BOMBA-Approved Smoke Spill Certification
Every installation is followed by a rigorous functional test. We provide the air velocity reports and "Cold Smoke" test results required by BOMBA for the issuance and renewal of your building's Fire Certificate (FC).
Engineering Accuracy in KL & PJ
As an M&E firm, we perform the complex Static Pressure (Ps) calculations needed to ensure your fan can overcome the resistance of fire-rated ductwork and vertical shafts without "stalling."
System-Wide Lifecycle Support
We don't just sell hardware. We provide total support—from the initial CFD Airflow Analysis and electrical cabling to annual bearing overhauls and motor insulation testing.
Rapid Response Maintenance
In the high-stakes environments of Kuala Lumpur's malls and office towers, a "Fan Fault" is an emergency. Our local teams provide rapid parts replacement and motor rewinding to get your life-safety systems back online.
Malaysia
