TLP251(TP1.F)
TLP251(TP1.F)

 

TLP251(TP1.F)

Utsource Holding Company Limited flag
Category: Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY TLP251(TP1.F) https://www.utsource.net/itm/p/9773947.html

Parameter Symbol Min Typ Max Unit Conditions
Input Forward Voltage VIF - 1.2 1.6 V IF = 10 mA, TA = 25°C
Input Current IF - - 20 mA VIF = 1.2 V
Output Collector-Emitter Voltage VCE(sat) - 0.3 0.5 V IC = 10 mA, TA = 25°C
Output Collector Current IC - - 15 mA VCE = 5 V
Isolation Voltage VIORM - - 5000 VRMS 1 min, 50/60 Hz
Operating Temperature TOP -40 - 85 °C -
Storage Temperature TS -40 - 100 °C -

Instructions for Using TLP251(TP1.F):

  1. Input Side:

    • Connect the input side to the control circuit.
    • Ensure the forward current (IF) is within the specified range to avoid damage.
    • The input forward voltage (VIF) should be between 1.2 V and 1.6 V at room temperature.

  2. Output Side:

    • Connect the output side to the load or the circuit being controlled.
    • The output collector-emitter voltage (VCE(sat)) should not exceed 0.5 V when the output transistor is saturated.
    • The maximum output collector current (IC) should not exceed 15 mA to prevent overheating.

  3. Isolation:

    • The device provides electrical isolation up to 5000 VRMS for 1 minute at 50/60 Hz.
    • Ensure that the isolation voltage is not exceeded to maintain safety and functionality.

  4. Temperature Considerations:

    • The operating temperature range is from -40°C to 85°C.
    • The storage temperature range is from -40°C to 100°C.
    • Avoid operating or storing the device outside these temperature ranges to prevent damage.

  5. Handling:

    • Handle the device with care to avoid static discharge.
    • Use appropriate ESD protection measures during handling and installation.

  6. Mounting:

    • Mount the device on a suitable PCB with proper heat dissipation if required.
    • Ensure that the connections are secure and free from shorts or open circuits.

  7. Testing:

    • Test the device in a controlled environment to ensure it meets the specified parameters before final installation.
    • Use a multimeter or an oscilloscope to verify the input and output characteristics.

By following these instructions, you can ensure the reliable operation and longevity of the TLP251(TP1.F) optocoupler.

(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag