Nippon Paint 5100 Wall Sealer is a water-based styrene acrylic sealer specifically formulated for use on exterior and interior masonry surfaces. It is designed to protect the finishing coats against the effects of alkalinity and efflorescence from the substrate, which can cause paint discoloration or peeling. This sealer provides a solid foundation by improving the adhesion between the substrate and the subsequent topcoat. It is an environmentally friendly choice with low VOC content and low odor, making it suitable for both residential and commercial projects. Its high-performance formula ensures that the final paint finish remains vibrant and durable over time.
Paint Type: Water-based (Interior & Exterior)
Finishing: Matt
Binder: Styrene Acrylic Emulsion
Thinning: Maximum 5% with clean water (preferably not diluted for best performance)
Touch Dry: 15 minutes (depending on temperature and humidity)
Hard Dry: 1 hour
Recoating Interval: Minimum 2 hours
Theoretical Coverage: 10 – 12 m² per litre per coat
No. of Coats: 1 coat
Shelf Life: Up to 36 months in a tightly sealed container
Application Method: Apply using a high-quality Brush, Roller, or Conventional Air Spray.
Dilution: Ready for use after thorough stirring. If thinning is necessary for workability, dilute with no more than 5% clean water.
Cleaning: Clean all painting equipment with clean water immediately after use.
Note: Do not apply when the temperature is below 10°C or when the humidity is very high.
Sealer/Primer (1 Coat): 5100 Wall Sealer.
Topcoat (2 Coats): Nippon Paint Interior or Exterior Products (e.g., Weatherbond, Satin Glo, or Vinilex Fresh).
For Repainting: Ensure the existing paint is stable before applying 5100 Wall Sealer as a bridging coat.
General Cleaning: Surfaces must be dry, clean, and free from dirt, grease, oil, and other foreign matter.
Defect Removal: Remove all loose, defective paint, powdery residues, dust, fungus, and algae by scraping or high-pressure water jetting.
Biological Treatment: Treat areas affected by fungus or algae growth with a suitable fungicidal wash solution.
Repair: Repair cracks and uneven surfaces with suitable masonry fillers and sand until smooth.
Moisture & Alkalinity: Ensure wall moisture content is below 16% (protimeter) and alkalinity is below pH 9 before application. New walls should be allowed to cure for at least 28 days.
Malaysia
